Request Quote
Home Questions Identifying Target Slave Device in CTS Mode After Adding External Devices

Identifying Target Slave Device in CTS Mode After Adding External Devices

6 views
0
0 Comments

Added 4 external slave devices and 1 internal master in the EX_PD mode, then, switched to CTS mode to test one slave, but in the I3C network it’s displaying there are still four slaves devices on the bus and couldn’t identify which slave is the target device?

Request For Quote

Thank you for visiting our website. Please take a moment to let us know which product you would like to request a quote for by filling the form below.

"*" indicates required fields

This field is for validation purposes and should be left unchanged.
Address*

Request For Demo

Thank you for visiting our website. Please take a moment to let us know which product you would like to request a demo for by filling out the form below.

"*" indicates required fields

This field is for validation purposes and should be left unchanged.
Address*

Request A Demo

Thank you for visiting our website. Please take a moment to let us know which product you would like to request a demo for by filling out the form below.

"*" indicates required fields

This field is for validation purposes and should be left unchanged.
This field is hidden when viewing the form
Address*
This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.